 |
 |
 |
|
|
|
[Sponsors] | ||||
July 31, 2013, 21:30
|
surface piercing foil ventilation
|
#1 |
|
Member
laurentL
Join Date: Oct 2011
Location: new caledonia
Posts: 73
Rep Power: 14  |
hi Foamers,
i am dealing since few months with this problems, free surface piercing foil ventilation or not. and i want to calculate drag and lift with OpenFoam. is anyone got indication where i can find some experimental results for validation of my OF settings... thanks LL |
|
|
|
|
|
January 15, 2014, 00:18
|
|
#2 |
|
Member
laurentL
Join Date: Oct 2011
Location: new caledonia
Posts: 73
Rep Power: 14 |
hi to all,
http://www.cfd-online.com/Wiki/Free-...0024_Hydrofoil good one, any other page like this for validation the OF results? is LTSInterFoam the best Solver for this problem? thank for helping LL |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
| Simulation of varying contact angles for a large droplet of water on a surface | cp703 | CFX | 5 | July 20, 2013 06:08 |
| solid edge problem....can you help? | cindy | Main CFD Forum | 3 | April 5, 2004 13:43 |
| Patran Volume Meshing | Deb | CFX | 19 | April 17, 2003 10:56 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |
1Likes
Linear Mode
