[yhaomin2007]

Hi, all foamers:

I want to imply another equation of state, so I copied the prefect gas file, and renamed it.

The compilation of the specie.so is successful, then I recompiled the solver. But when I run the solver it says:

Unknown basicPsiThermo type hPsiThermo<pureMixture<sutherlandTransport<specieT hermo<hConstThermo<RedlichKwong>>>>>

Valid basicPsiThermo types are:

11
(
ePsiThermo<pureMixture<constTransport<specieThermo <eConstThermo<perfectGas>>>>>
ePsiThermo<pureMixture<constTransport<specieThermo <hConstThermo<perfectGas>>>>>
ePsiThermo<pureMixture<sutherlandTransport<specieT hermo<eConstThermo<perfectGas>>>>>
ePsiThermo<pureMixture<sutherlandTransport<specieT hermo<hConstThermo<perfectGas>>>>>
ePsiThermo<pureMixture<sutherlandTransport<specieT hermo<janafThermo<perfectGas>>>>>
hPsiThermo<pureMixture<constTransport<specieThermo <hConstThermo<perfectGas>>>>>
hPsiThermo<pureMixture<sutherlandTransport<specieT hermo<hConstThermo<perfectGas>>>>>
hPsiThermo<pureMixture<sutherlandTransport<specieT hermo<janafThermo<perfectGas>>>>>
hsPsiThermo<pureMixture<constTransport<specieTherm o<hConstThermo<perfectGas>>>>>
hsPsiThermo<pureMixture<sutherlandTransport<specie Thermo<hConstThermo<perfectGas>>>>>
hsPsiThermo<pureMixture<sutherlandTransport<specie Thermo<janafThermo<perfectGas>>>>>
)



From function basicPsiThermo::New(const fvMesh&)
in file psiThermo/basicPsiThermo/basicPsiThermoNew.C at line 60.

it seems that I have to put the new equation of state to somewhere.

Could somebody help me with this??

thank you in advance.

[olivierG]

hello,

You should take a look at this thread:
http://www.cfd-online.com/Forums/ope...roperties.html

regards,
olivier

[yhaomin2007]

thank you very much~

[yhaomin2007]

hi, olivier:

I have seen the threads that you quoted. but I did not find the clear solution in it.

Do you have any ideas?

thank you

[olivierG]

hello,

In this post http://www.cfd-online.com/Forums/ope...tml#post263539 you will find a step by step method.

Due to the multi layer structure in the thermoType, you need do modify more than one file. I don't know an easy "Howto" for that.

regards,
olivier