|October 4, 2012, 07:26||
How to sample a cut in domain which respects boundary conditions
After running a laminar, axisymmetric, case in OF2.1.0 I run into the following problem:
I am extracting pressure and velocity in a slice through an axisymmetric domain sampling a steady solution after it finished and not getting what I expected.
Mainly, this procedure either doesn't extract the field values at each boundary, for example Ux=Uy=Uz=0 at Wall, or it just extrapolates some value at the boundary without paying attention to the type of boundary it is.
If I transform the solution to FLUENT, and extract from there the same slice, I get the field values I should expect at boundaries.
I would like to avoid going through FLUENT every time.
|Thread||Thread Starter||Forum||Replies||Last Post|
|mesh file for flow over a circular cylinder||Ardalan||Main CFD Forum||6||April 17, 2010 23:40|
|No results for solid domain||Gary Holland||CFX||10||March 13, 2009 04:30|
|Boundary conditions on a wake cut||sjs||OpenFOAM Running, Solving & CFD||3||August 6, 2008 21:56|
|New topic on same subject - Flow around race car||Tudor Miron||CFX||15||April 2, 2004 06:18|
|Please help with flow around car modelling!||Tudor Miron||CFX||17||March 19, 2004 20:23|