|
[Sponsors] |
April 2, 2013, 07:11 |
Help with tutorial
|
#1 |
New Member
Join Date: Apr 2013
Posts: 11
Rep Power: 13 |
I am looking for some guidance on openFOAM MS (openfoam desinger v 1.0) . I am new to OpenFOAM and I have been following the tutorial case cavity, but have had problems when running paraview. I was able generate the mesh and paraview loaded fine but I am not able to load any files of this tutorial into paraview. I am running openFOAM under win7, 64bit bootcamped Mac.
Thanks, any help is greatly apreciated. |
|
Tags |
openfoam ms paraview |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tutorial for subcooled nucleate boiling | Asghari | FLUENT | 42 | December 10, 2018 11:42 |
Problem on Fluent Tutorial: Horizontal Film Boilig | Feng | FLUENT | 2 | April 13, 2013 05:34 |
[Virtualization] OpenFOAM oriented tutorial on using VMware Player - support thread | wyldckat | OpenFOAM Installation | 2 | July 11, 2012 16:01 |
Rotor/stator tutorial, and how to... | gilberto | CFX | 5 | January 21, 2002 09:41 |