|
[Sponsors] |
use paraview to visualize the openfoam output results |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 22, 2013, 15:33 |
use paraview to visualize the openfoam output results
|
#1 |
Senior Member
Join Date: Nov 2012
Posts: 171
Rep Power: 13 |
Hi All,
When I finish a parallel computation, for example 8 coes, when I would like to see the results with paraview, now I always first use the command reconstruct to combine the data and then the paraview to open them. I am wondering if there is a method to see the results using paraview without combing the data first. Because if the data are very large then the combining is very time consuming and comsume lots of space. Thank you very much. |
|
July 23, 2013, 01:39 |
|
#2 |
Senior Member
Bernhard
Join Date: Sep 2009
Location: Delft
Posts: 790
Rep Power: 21 |
Select "Decomposed Case" from Case Type, instead of Reconstructed Case"
|
|
July 23, 2013, 08:18 |
|
#3 |
Senior Member
Join Date: Nov 2012
Posts: 171
Rep Power: 13 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] Questions about Paraview to show Parallel run of OpenFOAM | padian | ParaView | 20 | September 24, 2018 12:52 |
Paraview Compiling Error (OpenFOAM 2.1.x + openSUSE 12.2) | sfigato | OpenFOAM Installation | 22 | January 31, 2013 10:16 |
Visualize results from ANSYS Ls-Dyna, | mechanicaldesign | ANSYS | 0 | January 21, 2013 23:37 |
Velocity vector data in OpenFOAM and ParaView mismatch | tekky | OpenFOAM | 9 | December 21, 2009 11:26 |
OpenFOAM 1.5.x package - CentOS 5.3 x86_64 | linnemann | OpenFOAM Installation | 7 | July 30, 2009 03:14 |