 |
 |
 |
|
|
|
[Sponsors] | ||||
July 31, 2013, 11:14
|
New pc for OPEN foam
|
#1 |
|
New Member
Join Date: May 2013
Posts: 6
Rep Power: 12  |
Hello Foamers,
I am writing this today as I need a little help in deciding what computer to buy. I am relatively new to OF and I would like to use it for the following applications: - importing cad drawings and subsequent meshing of offshore platforms - Ventilation studies - Gas dispersion - Fire modelling From experience it seems that the number of cells required lies between 2 and 5 millions. I am not a computer expert by any stretch of the imagination so would like your feedback based on two possible options. Let it be told that I cannot build a machine by myself and my budget is around the £2,000.00 mark. Option 1) http://configure.us.dell.com/dellsto...en&s=bsd&cs=04 Option 2) http://www.meshcomputers.com/Default...omepage_dtbox2 I would greatly appreciate your feedback on these options and any tweaks required to make the most of my simulations. Thank you for your time Falstaff |
|
|
|
|
|
August 1, 2013, 02:25
|
|
#2 |
|
Senior Member
|
||
|
|
|
|
|
August 1, 2013, 08:04
|
sorry
|
#3 |
|
New Member
Join Date: May 2013
Posts: 6
Rep Power: 12 |
Sorry for misplacing this. Thanks for the pointers.
Regards |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| [Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |
Linear Mode
