Where is 'transportProperties' in the solver 'twoPhaseEulerFoam' 2.3.0?

mxylondon · March 27, 2014, 15:28

Hi guys,
I just found the file 'transportProperties' is gone in those cases for 2.3.0 version 'twoPhaseEulerFoam'. And there is no density definition in 'thermalphysicalProperties.air'.
Anyone knows where to define it?

Thanks.

wouter · March 27, 2014, 18:32

Hello mxylondon
I think it is calculated by the perfect gas law PV=nRT and rho = n*W/V.

hope this helps
Wouter

mxylondon · March 28, 2014, 04:30

Ah ha! I see, it depends on the setup of 'equationOfState'. Thank you!

March 27, 2014, 15:28	Where is 'transportProperties' in the solver 'twoPhaseEulerFoam' 2.3.0?	#1
mxylondon Member X Meng Join Date: Jun 2012 Location: Scotland Posts: 89 Rep Power: 15	Hi guys, I just found the file 'transportProperties' is gone in those cases for 2.3.0 version 'twoPhaseEulerFoam'. And there is no density definition in 'thermalphysicalProperties.air'. Anyone knows where to define it? Thanks.

March 27, 2014, 18:32		#2
wouter Senior Member Wouter van der Meer Join Date: May 2009 Location: Elahuizen, Netherlands Posts: 203 Rep Power: 19	Hello mxylondon I think it is calculated by the perfect gas law PV=nRT and rho = nW/V. hope this helps Wouter RjwV likes this. Last edited by wouter; March 27, 2014 at 18:33. Reason: typo*

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
compiling error(s) in a modified twoPhaseEulerFoam solver	foamer	OpenFOAM	14	June 20, 2014 09:51
Strange residuals of the Density Based Solver	Pat84	FLUENT	0	October 22, 2012 16:59
Quarter Burner mesh with periosic condition	SamCanuck	FLUENT	2	August 31, 2011 12:34
why the solver reject it? Anyone with experience?	bearcat	CFX	6	April 28, 2008 15:08
Error during Solver	cfd guy	CFX	4	May 8, 2001 07:04

March 28, 2014, 04:30		#3
mxylondon Member X Meng Join Date: Jun 2012 Location: Scotland Posts: 89 Rep Power: 15	Ah ha! I see, it depends on the setup of 'equationOfState'. Thank you!