LES Simulation of 5-to-1 rectangular prism

tung.nguyen · July 2, 2014, 04:55

Dear Foamers,

I am currently learning how to use OpenFOAM to 2D simulation vortex shedding of a 5-to-1 rectangular prism using LES in turbulence-free condition. I have followed OF tutorials to set up my case. I know 2D with LES in OF is not a good choice but I would like to set up a proper case in 2D first before switching to 3D.

My case runs alright but it gave me very high Strouhal number. Literature review shows St about 0.12 but my results are consistently between 0.16 - 0.2. The Reynold number is 600 and 6000. I am using Smagorinsky model to start up with.

Could anyone who have been researching on the similar topic give me a bit more insight into what could be my problem? Any responses are very appreciated.

Sincerely,

Tung.

tung.nguyen · July 2, 2014, 04:56

Here is the mesh that I am using for my LES simulation and the velocity contour at Re = 6000 which is very strange to me since there are more vortices being resolved than expected. Thank you very much.

meshV30.jpg

flowField.jpg

July 2, 2014, 04:55	LES Simulation of 5-to-1 rectangular prism	#1
tung.nguyen New Member Join Date: May 2014 Posts: 4 Rep Power: 11	Dear Foamers, I am currently learning how to use OpenFOAM to 2D simulation vortex shedding of a 5-to-1 rectangular prism using LES in turbulence-free condition. I have followed OF tutorials to set up my case. I know 2D with LES in OF is not a good choice but I would like to set up a proper case in 2D first before switching to 3D. My case runs alright but it gave me very high Strouhal number. Literature review shows St about 0.12 but my results are consistently between 0.16 - 0.2. The Reynold number is 600 and 6000. I am using Smagorinsky model to start up with. Could anyone who have been researching on the similar topic give me a bit more insight into what could be my problem? Any responses are very appreciated. Sincerely, Tung.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
LES Simulation Blowing Up	deji	OpenFOAM	0	December 10, 2011 14:14
validation LES Simulation	s&m	OpenFOAM Running, Solving & CFD	0	January 29, 2010 17:12
LES simulation of bluff body at Re(d)=1200	arash_nl	FLUENT	0	June 1, 2009 13:16
LES simulation of vibrating Wing	gtg627e	OpenFOAM Running, Solving & CFD	0	September 6, 2007 01:36
LES simulation of sonic jet	Jianping	Main CFD Forum	0	January 21, 2005 05:52

July 2, 2014, 04:56		#2
tung.nguyen New Member Join Date: May 2014 Posts: 4 Rep Power: 11	Here is the mesh that I am using for my LES simulation and the velocity contour at Re = 6000 which is very strange to me since there are more vortices being resolved than expected. Thank you very much. meshV30.jpg flowField.jpg