|
[Sponsors] |
![]() |
![]() |
#1 |
Member
sirLentschi
Join Date: Nov 2010
Posts: 87
Rep Power: 16 ![]() |
Hello!
I want to use the probes-function in order to record the pressure p at some specific points. In that case, all monitoring points have to rotate with the wall (which is part of a rotating cellZone), so that the relativ position is always the same! Is there any possibility in this mentioned function to perform that? Best Regards, Markus |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Mar 2010
Location: Germany
Posts: 154
Rep Power: 16 ![]() |
Hi,
I'm neither using extend, nor rotating systems yet. I want to share an idea though: Maybe you could use the #codeStream directive (http://www.openfoam.org/version2.0.0...me-control.php) to compute the correct position of the probes at run time. Good luck! Cutter |
|
![]() |
![]() |
![]() |
![]() |
#3 | |
Senior Member
Sergei
Join Date: Dec 2009
Posts: 261
Rep Power: 22 ![]() |
Quote:
|
||
![]() |
![]() |
![]() |
![]() |
#4 |
New Member
Ali
Join Date: Nov 2011
Posts: 9
Rep Power: 15 ![]() |
You can do it in paraview itself. There is plot over selection time in filter. Before applying plot over selection time, you need to create point or cell selection in paraview. I hope it helps.
|
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 18:22 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 10:56 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 09:19 |