Flow simulation through a membrane

sk11 · April 11, 2018, 06:18

Hi All,
I am trying to have a simulation of fishing nets in OpenFOAM and was wondering if there is any way to consider the fishing net as a surface instead of solid cylinders ( Or considering them as a porous membrane with infinitesimal thickness ). Meshing over each twine of large nets will make the simulation computationally expensive. I hope to have a coupled problem and input to the fluid simulation as points (Or Lines representing the Net).
I found MembraneFoam, which was developed to model Forward Osmosis Water treatment. But I could not find a way to do it for fishing nets since the flow was not due to a difference in concentration like how it is in forward osmosis.
Thanks in advance for your valuable advice and inputs.

Sarath

tomf · April 12, 2018, 02:56

Hi,

The porousBafflePressure comes to mind.

This would lead to a pressure jump as an effect of normal velocity, which seems to be what you are aiming for?

Regards,
Tom

sk11 · April 12, 2018, 04:23

This is something interesting to my case. I will look forward to try them. Thanks a lot for your suggestion Tom.

Regards,
Sarath

April 11, 2018, 06:18	Flow simulation through a membrane	#1
sk11 New Member Sarath Join Date: Mar 2017 Location: Spain Posts: 22 Rep Power: 9	Hi All, I am trying to have a simulation of fishing nets in OpenFOAM and was wondering if there is any way to consider the fishing net as a surface instead of solid cylinders ( Or considering them as a porous membrane with infinitesimal thickness ). Meshing over each twine of large nets will make the simulation computationally expensive. I hope to have a coupled problem and input to the fluid simulation as points (Or Lines representing the Net). I found MembraneFoam, which was developed to model Forward Osmosis Water treatment. But I could not find a way to do it for fishing nets since the flow was not due to a difference in concentration like how it is in forward osmosis. Thanks in advance for your valuable advice and inputs. Sarath

April 12, 2018, 02:56		#2
tomf Senior Member Tom Fahner Join Date: Mar 2009 Location: Breda, Netherlands Posts: 634 Rep Power: 32	Hi, The porousBafflePressure comes to mind. This would lead to a pressure jump as an effect of normal velocity, which seems to be what you are aiming for? Regards, Tom sk11 likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
About Some Concepts:Laminar flow, turbulent flow, steady flow and time-dependent flow	Jing	Main CFD Forum	8	October 5, 2018 17:02
Numerical simulation of DBD plasma actuator induced flow	mukut	OpenFOAM	5	January 7, 2014 05:30
Convergence of jet flow simulation	MiraLisa	FLUENT	0	August 15, 2013 04:44
Coupling of drying process and flow simulation	franzdrs	Main CFD Forum	0	April 29, 2013 14:11
Expert parameter to stop the fluid flow simulation	KK	CFX	1	February 25, 2008 16:29

April 12, 2018, 04:23		#3
sk11 New Member Sarath Join Date: Mar 2017 Location: Spain Posts: 22 Rep Power: 9	This is something interesting to my case. I will look forward to try them. Thanks a lot for your suggestion Tom. Regards, Sarath