Internal faces JUST for post-processing purposes

spitchers · February 3, 2017, 07:59

Hello everyone,

I was wondering how I would go about creating two internal faces in my model for post-processing purposes. They have no physical relevance in my model and I just want to get the pressure and temperature difference between the two and use them for creating Vector Contours in Paraview.

Would I need to create the faces during the post-processing stage? Or can I just add them as an STL at the end in paraview ?

Sent from my iPhone using CFD Online Forum mobile app

khedar · February 3, 2017, 08:21

You may find this post relevant.

https://www.cfd-online.com/Forums/op...tml#post635747

February 3, 2017, 07:59	Internal faces JUST for post-processing purposes	#1
spitchers New Member Suffolk Join Date: Nov 2015 Posts: 26 Rep Power: 10	Hello everyone, I was wondering how I would go about creating two internal faces in my model for post-processing purposes. They have no physical relevance in my model and I just want to get the pressure and temperature difference between the two and use them for creating Vector Contours in Paraview. Would I need to create the faces during the post-processing stage? Or can I just add them as an STL at the end in paraview ? Sent from my iPhone using CFD Online Forum mobile app

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[mesh manipulation] Importing Multiple Meshes	thomasnwalshiii	OpenFOAM Meshing & Mesh Conversion	18	December 19, 2015 18:57
decomposePar -allRegions	stru	OpenFOAM Pre-Processing	2	August 25, 2015 03:58
foam-extend_3.1 decompose and pyfoam warning	shipman	OpenFOAM	3	July 24, 2014 08:14
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36
Unaligned accesses on IA64	andre	OpenFOAM	5	June 23, 2008 10:37

February 3, 2017, 08:21		#2
khedar Senior Member khedar Join Date: Oct 2016 Posts: 111 Rep Power: 9	You may find this post relevant. https://www.cfd-online.com/Forums/op...tml#post635747