 |
 |
 |
|
|
|
[Sponsors] | ||||
September 25, 2017, 09:53
|
Bad snappyHexMesh transition
|
#1 |
|
New Member
Mosaad
Join Date: Aug 2017
Posts: 2
Rep Power: 0  |
Dear all,
I am trying to generate mesh with 3 different level of refinement. But I always obtain a bad transition between them as show in the following picture. How can I overcome this problem ? Regards, |
|
|
|
|
|
September 25, 2017, 11:32
|
|
#2 |
|
Member
Brian Willis
Join Date: Mar 2011
Location: Cape Town, South Africa
Posts: 58
Rep Power: 15 |
Your mesh may be fine. When viewing a slice in Paraview, apply the option of crinkle cut to view the mesh without any kind of interpolation which is probably what you are seeing in the attached photo.
|
|
|
|
|
|
|
September 25, 2017, 13:03
|
|
#3 |
|
Member
Icaro A. Accordi
Join Date: Oct 2010
Posts: 31
Rep Power: 15 |
...and unclick decompose polyhedra
|
|
|
|
|
|
|
September 28, 2017, 07:46
|
Solved
|
#4 |
|
New Member
Mosaad
Join Date: Aug 2017
Posts: 2
Rep Power: 0 |
Thanks all un-checking the "decompose polyhedral" and crinkle solved the problem
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh Parallel bad size error | andrewpomeroy | OpenFOAM Meshing & Mesh Conversion | 2 | April 2, 2018 01:08 |
| [snappyHexMesh] bad trailing edge boundary layer with snappyHexMesh | draufunddran | OpenFOAM Meshing & Mesh Conversion | 14 | March 1, 2018 09:42 |
| [snappyHexMesh] snappyHexMesh: Bad snapping on shallow slopes | matthiasd | OpenFOAM Meshing & Mesh Conversion | 5 | February 1, 2017 17:23 |
| [Other] Bad Mesh transition | BakedAlmonds | OpenFOAM Meshing & Mesh Conversion | 1 | July 21, 2016 05:18 |
| [snappyHexMesh] Remove snappyHexMesh bad cells (subSetMesh) | jet_engine | OpenFOAM Meshing & Mesh Conversion | 1 | June 24, 2016 09:31 |
5Likes
Linear Mode
