Simulation of air flow around a PV module: nothing appears

BlakeV · March 25, 2018, 20:27

I am very new of openFOAM. Recently, I ran a simulation of air flow around a PV module. I replace the tutorial motorBike model by mine, yet there is nothing shown after running the simulation process. I checked my scale of my model and it's the same as the original motorBile model. Right now I am stuck and really have no idea where my problem is.

Svetlana · March 26, 2018, 00:25

Could you include a link to the original model that you started from and a screenshot of the results that you are getting? Are you running a steady state or a transient simulation?

BlakeV · March 26, 2018, 02:41

I attached my result figure below.
The link is my module obj file.
https://www.dropbox.com/s/w8ifxxgzbj...odule.obj?dl=0

Svetlana · January 7, 2019, 01:32

The attached file is geometry. Where do you specify the boundary conditions?

March 25, 2018, 20:27	Simulation of air flow around a PV module: nothing appears	#1
BlakeV New Member Naifu Xu Join Date: Mar 2018 Posts: 3 Rep Power: 9	I am very new of openFOAM. Recently, I ran a simulation of air flow around a PV module. I replace the tutorial motorBike model by mine, yet there is nothing shown after running the simulation process. I checked my scale of my model and it's the same as the original motorBile model. Right now I am stuck and really have no idea where my problem is.

March 26, 2018, 00:25	asking for link and screenshot	#2
Svetlana Senior Member Svetlana Tkachenko Join Date: Oct 2013 Location: Australia, Sydney Posts: 428 Rep Power: 16	Could you include a link to the original model that you started from and a screenshot of the results that you are getting? Are you running a steady state or a transient simulation?

January 7, 2019, 01:32	setup details	#4
Svetlana Senior Member Svetlana Tkachenko Join Date: Oct 2013 Location: Australia, Sydney Posts: 428 Rep Power: 16	The attached file is geometry. Where do you specify the boundary conditions?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Some questions about flow boiling simulation in Fluent	beastieboys6	FLUENT	8	November 21, 2017 00:47
Problem with an old Simulation	FrankW	CFX	3	February 8, 2016 05:28
two-phase flow with a single phase simulation	caunima	Fluent Multiphase	0	October 28, 2013 03:42
Modeling the mixing of air and kerosene in a flow channel	StefanG	CFX	3	June 11, 2012 21:21
Multiphase flow - simulation crashing	yschati	CFX	14	November 16, 2010 18:29