"pcorr is not specified" in foam-extend-4.0
 

Dear OpenFOAM users,

I compiled successfully a custom solver in fe31 and it runs. However, when I compile it in fe40, some changes should be made:

1) Time.H (fe31) changes to foamTime.H(fe40)
2) readTimeControls.H (fe31) changes to createTimeControls.H (fe40)

And it compiled without any problems.

But!!! When I run the solver to a case, it says:

My question is, is there other difference between fe31 and fe40? Why it runs under fe31 but not in fe40???

Thanks for any reply.

Best,
Hao

Is that iInterFoam103???
 

Dear Noémie:
I wonder is the solver you mentioned is iInterFoam103 created by A.Q.Raeini? Frankly speaking, i am facing the same problem while i am trying to use this solver on cluster. So I wonder if you have solved this problem yet? Any instructions would be very helpful!
Many thanks!
Best wishes
Shepherd

Hi Shepherd,

no, I'm using a coupled solver developed by our group, it couples interFoam with another custom 2D solver called shallowFoam.

With the aforementioned changes, the 2D solver compiles and runs. But the coupled solver fail to run. So now I'm still working this solver with foam-extend-3.1.

Best,

Hao

Now I can only compile it with foam-extend-3.1.