 |
 |
 |
|
|
|
[Sponsors] | ||||
February 20, 2019, 12:31
|
Pressure Reference
|
#1 |
|
Member
Join Date: Jun 2011
Location: Germany
Posts: 59
Rep Power: 16  |
Hello,
is there a feature like Fluent/CFX in OpenFOAM to set up an reference pressure for Simple, Pimple Solver? e.g. 1 atm If it is possible, is the value also used at BC values? e.g. Pressure Outlet = Value in Dict + Reference Pressure Thanks, Thomas |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 13:23 |
| Domain Reference Pressure and mass flow inlet boundary | AdidaKK | CFX | 75 | August 20, 2018 06:37 |
| reference pressure and compressible flow | bingo10 | CFX | 0 | September 11, 2013 08:32 |
| OpenFOAM 1.6 ext - Compilation errors - Fedora 17(32bit) | toolpost | OpenFOAM Installation | 15 | September 21, 2012 10:38 |
| about reference pressure | adam2008 | CFX | 1 | May 17, 2011 09:03 |
Linear Mode
