How to set negative slippage in OpenFOAM? -- CFD Online Discussion Forums

October 23, 2019, 22:44

How to set negative slippage in OpenFOAM?

Excercise

New Member

Excercise

Join Date: Feb 2019

Posts: 11

Rep Power: 8

Hello, everyone！
I would like to ask how to set a negative slippage as shown in the figure in OpenFOAM.
Thanks for your help.

Attached Images

slippage.png (26.8 KB, 6 views)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] mesh airfoil NACA0012	anand_30	OpenFOAM Meshing & Mesh Conversion	13	March 7, 2022 17:22
[ICEM] ICEM Scripting Issues	tylerplowright	ANSYS Meshing & Geometry	33	September 27, 2021 16:35
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 13:43
OpenFOAM installation on SUSE92 problems	derath	OpenFOAM Installation	1	April 3, 2006 06:44
How to set environment variables	kanishka	OpenFOAM Installation	1	September 4, 2005 10:15

All times are GMT -4. The time now is 08:07.