addr2line failed error and Segmentation fault error

shivamswarnakar72 · June 4, 2020, 04:49

Hello everyone,

My simulation stops after running for about 20 hours. I am using HPC facility for simulation. Openfoam version is v1712.
After running about 20 hours, job gets killed by showing following error (attached below).

I am unable to solve this issue. So I am asking for forums help.

Note: The code is a modified buoyancy based heat transfer solver present in Openfoam. This error didn't occured on my desktop and it ran for weeks without any error.

shivamswarnakar72 · July 5, 2020, 06:02

Quote:

Originally Posted by shivamswarnakar72

Hello everyone,

My simulation stops after running for about 20 hours. I am using HPC facility for simulation. Openfoam version is v1712.
After running about 20 hours, job gets killed by showing following error (attached below).

I am unable to solve this issue. So I am asking for forums help.

Note: The code is a modified buoyancy based heat transfer solver present in Openfoam. This error didn't occured on my desktop and it ran for weeks without any error.

Anyone know about this issue?