OpenFOAM wave tutorial question.
 

Hello.

I am currently doing a tutorial at interFoam/laminar/waves at OpenFOAM.

Unlike the dambreak tutorial, when you start the calculation, the files postProcessing, Processor0, and Processor1 are created.

Is there anyone who would be grateful to explain this part?


And there is another one.

In the case of damdreak, the calculation starts with blockMesh -> Setfield -> interFoam in the terminal, but in the case of waves, the calculation is not performed by following the same procedure. Is there a way to start the calculation in a similar way to dambreak rather than ./Allrun?