 |
 |
 |
|
|
|
[Sponsors] | ||||
How to define the reattachment point of a BFS flow? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 7, 2021, 10:44
|
How to define the reattachment point of a BFS flow?
|
#1 |
|
New Member
Song Xiaodan
Join Date: Oct 2020
Posts: 3
Rep Power: 7  |
Hello everyone:
I am using OpenFOAM for my search about BFS flow with different ERs. I am confusing with how to define the reattachment point, as there are more than one circulation region, how can I define the primary circulation region to define the reattachment point? Thanks a lot! |
|
|
|
|
|
| Tags |
| backward facing step, openfoam, reattachment length |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] How to define to right point for locationInMesh | Mirage12 | OpenFOAM Meshing & Mesh Conversion | 7 | March 13, 2016 15:07 |
| Can anyone tell me how to define inlet flow angle for a centrifugal turbine? | hntter | CFX | 0 | March 8, 2015 08:47 |
| Non-steady flow simplified for use in Vissim | steamerandy | Main CFD Forum | 0 | October 31, 2011 22:08 |
| [Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 03:27 |
| how to define mass flow rate in CFX-Pre | Atit Koonsrisuk | CFX | 1 | February 16, 2005 14:45 |
Linear Mode
