 |
 |
 |
|
|
|
[Sponsors] | ||||
Boundary conditions set for patches of the bounding box |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 28, 2024, 11:37
|
Boundary conditions set for patches of the bounding box
|
#1 |
|
New Member
Join Date: Jun 2024
Posts: 7
Rep Power: 2  |
Hi everyone,
I want to simulate the fluid extruded from a nozzle using openfoam. Firstly, I do meshing with blockMesh to create a bounding box around the nozzle stl surface and then create the mesh of the stl using snappyhexmesh. The nozzle has two faces as inlet and outlet. My question is how I can assign the boundary conditions for the surrounding box created by blockMesh? In particular, I mean the p and U files in 0 folder. Thank you for reading. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to set boundary conditions for cylinder+orifice mesh | JD_PM | OpenFOAM Running, Solving & CFD | 0 | March 1, 2022 06:02 |
| Problem in setting Boundary Condition | Madhatter92 | CFX | 12 | January 12, 2016 05:39 |
| Waterwheel shaped turbine inside a pipe simulation problem | mshahed91 | CFX | 3 | January 10, 2015 12:19 |
| Radiation interface | hinca | CFX | 15 | January 26, 2014 18:11 |
| Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 08:00 |
Linear Mode
