[jmex]

Hello folks,

I am found engine2valve2D in tutorials. The model is formed using blockMeshDict.
I want to use this or similar module to perform simulation for a 3D model. I am not concerned with the combustion but just want to check for flow across the intake and exhaust during the cycle. Can someone guide how do I approach?

Thanks alot in advance.

[jmex]

I have prepared the mesh and importing the mesh file in openfoam. Just one doubt, the simulation engine2valve2D creates different meshing at different position of valves and piston, how will it happen if I import it instead of using blockMeshDict file?