 |
 |
 |
|
|
|
[Sponsors] | ||||
Line 140 make command not found What is the solution |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 12, 2006, 16:25
|
Hi
while I try to compile cod
|
#1 |
|
New Member
Faroque Hossain
Join Date: Mar 2009
Posts: 5
Rep Power: 18  |
Hi
while I try to compile code with wmake I am getting following error msg. + wmake mhdFoam /home/faroque/OpenFOAM/OpenFOAM-1.3/wmake/wmake: line 140: make: command not found /home/faroque/OpenFOAM/OpenFOAM-1.3/wmake/wmake: cannot make, file Make/linuxGcc4DPOpt/objectFiles was not created successfully does anyone have any idea how to solve this problem? Thanks in advance. -- Faroque |
|
|
|
|
|
November 13, 2006, 05:16
|
Do you have 'make'? I have
|
#2 |
|
Senior Member
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,419
Rep Power: 27 |
Do you have 'make'? I have
/usr/bin/make To compile OpenFOAM you will need a full development installation on your system ('make', 'ld', 'as'). You can usually install these from your operating system disk. |
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] ParaView command not found | joey | ParaView | 12 | January 18, 2021 06:38 |
| [OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 05:59 |
| Problem of compilation OF 14Allwmake command not found | erik_d | OpenFOAM Bugs | 13 | September 13, 2008 22:45 |
| Bash g command not found | mamaly60 | OpenFOAM Installation | 0 | October 18, 2007 18:14 |
| Error starting paraFoam line 67 paraview command not found | jango | OpenFOAM Installation | 4 | July 19, 2007 02:39 |
Linear Mode
