 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] SnappyHexMesh and sharp corners |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 7, 2009, 05:07
|
SnappyHexMesh and sharp corners
|
#1 |
|
Senior Member
Anonymous
Join Date: Mar 2009
Posts: 110
Rep Power: 17  |
I've meshed a box within a box using snappyHexMesh as a tester. However, it is failing to resolve the sharp edges and also doesn't grow any prism layers there. I've set resolveFeatureAngle to 10deg and there are a couple of refinement boxes around it.
Does anyone else have any good settings they can provide for meshing sharp corners? |
|
|
|
|
|
September 7, 2009, 08:32
|
|
#2 |
|
Senior Member
Pei-Ying Hsieh
Join Date: Mar 2009
Posts: 334
Rep Power: 18 |
HI,
I believe that current snappyHexMesh does not support feature lines. Some people on this forum had mentioned that the feature lines may be supported in the future, but, I am not sure when it will happen. pei |
|
|
|
|
|
|
September 7, 2009, 09:26
|
|
#3 |
|
Senior Member
Anonymous
Join Date: Mar 2009
Posts: 110
Rep Power: 17 |
Thanks, Pei. That will explain the issue.
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] ShM: problems at sharp edges | Coris | OpenFOAM Meshing & Mesh Conversion | 1 | July 11, 2016 21:23 |
| [snappyHexMesh] snappyHexMesh runs endless - I need general advise | TeresaT | OpenFOAM Meshing & Mesh Conversion | 5 | November 17, 2015 02:50 |
| [snappyHexMesh] snappyHexMesh on sharp corners (cube) | Regis_ | OpenFOAM Meshing & Mesh Conversion | 0 | June 4, 2015 23:47 |
| [snappyHexMesh] Problem with snappyhexMesh: modelling a pore chamber and pore throat model | Saideep | OpenFOAM Meshing & Mesh Conversion | 5 | May 10, 2015 14:46 |
| [snappyHexMesh] SnappyHexMesh: Layer on corners | Pj. | OpenFOAM Meshing & Mesh Conversion | 9 | July 17, 2014 04:26 |
Linear Mode
