OpenFoam Beginner
Hi iam a beginner in openfoam.. i want to simulate cube with inlet on one phase and outlet on a oposite.. i started with modifying the geometry in the tutorial cavity... ..my question is how do i describe inlets and oultets?.. I got an error when I ran block mesh... any suggestions?
|
hi,
post your blockMeshDict-file and the corresponding error message. Christof |
hey thanks for the reply... I resolved the issue..Now i am working on an other simple analysis...a room with a heat source on the floor.Both the room and heat source are cubes. To put it simple.. it is a cube inside cube..the inner cube is the heat source.. is it easy to model this problem?..
|
All times are GMT -4. The time now is 17:47. |