Stream Function - How to Visualise It?

ternik · October 2, 2009, 11:19

I am running tutorial case (driven cavity) just to check "if & how" works the streamFunction utility... I am getting results (streamFunction) for each time step, but unfortunately I can not visualise it with the ParaView! Can you please give some hints on this...

I am also wondering if it is possible to plot streamFunction with the sample utility? If so, I am looking forward for a "cook-book" on this as well!

Thanks in advance,
Primoz,

P.S.: I am using OF-1.5...

hjasak · October 3, 2009, 06:07

You need to visualise iso-lines of stream function on a cut through the cavity.

This will give you the stream tubes. Please note: stream function is only defined in 2-D.

Enjoy,

Hrv

ternik · October 3, 2009, 06:55

thanks for your reply. Unfortunately, results for the stream function (as calculated with a "streamFunction" utility) are not loaded when running the Paraview - if I am not mistaken, I should be able to see & load results under the Point Field Status within the ParaView...

Any further suggestions are more than welcome and highly appreciated!

Wish you a nice day,
Primoz.

October 2, 2009, 11:19	Stream Function - How to Visualise It?	#1
ternik Member Primoz Ternik Join Date: Apr 2009 Location: Maribor, Slovenia Posts: 65 Rep Power: 17	I am running tutorial case (driven cavity) just to check "if & how" works the streamFunction utility... I am getting results (streamFunction) for each time step, but unfortunately I can not visualise it with the ParaView! Can you please give some hints on this... I am also wondering if it is possible to plot streamFunction with the sample utility? If so, I am looking forward for a "cook-book" on this as well! Thanks in advance, Primoz, P.S.: I am using OF-1.5...

October 3, 2009, 06:07		#2
hjasak Senior Member Hrvoje Jasak Join Date: Mar 2009 Location: London, England Posts: 1,905 Rep Power: 33	You need to visualise iso-lines of stream function on a cut through the cavity. This will give you the stream tubes. Please note: stream function is only defined in 2-D. Enjoy, Hrv __________________ Hrvoje Jasak Providing commercial FOAM/OpenFOAM and CFD Consulting: http://wikki.co.uk

October 3, 2009, 06:55	Hi Hrvoje,	#3
ternik Member Primoz Ternik Join Date: Apr 2009 Location: Maribor, Slovenia Posts: 65 Rep Power: 17	thanks for your reply. Unfortunately, results for the stream function (as calculated with a "streamFunction" utility) are not loaded when running the Paraview - if I am not mistaken, I should be able to see & load results under the Point Field Status within the ParaView... Any further suggestions are more than welcome and highly appreciated! Wish you a nice day, Primoz.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Compile problem	ivanyao	OpenFOAM Running, Solving & CFD	1	October 12, 2012 09:31
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
Error with Wmake	skabilan	OpenFOAM Installation	3	July 28, 2009 00:35
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00