Explosion inside a cube - blockMesh

shangzung · October 21, 2009, 05:21

Hello!

I want to model a a simple cube and simulate an explosion inside that cube. I thought of another small cube that has high pressure in it, which is ater a while released into the big cube.

Since I am very new with blockMesh, for modelling that in blockMesh I have a question. How many blocks do I have to create at least? Are two blocks (big cube, small cube) enough or won't blockMesh work that way and I will have to create tons of blocks?

shangzung · October 21, 2009, 07:38

I found out that I don't have to create an additional block at all for the case. Just one block is enough.

anmartin · January 16, 2013, 13:00

Quote:

Originally Posted by shangzung

I found out that I don't have to create an additional block at all for the case. Just one block is enough.

Hello,

Which solver did you use for your simulation.

Regards

CharlieTan84 · March 6, 2013, 03:59

Hello!
Which solver are you using to simulate a TNT Explosion on OpenFoam?
Thank you so much!

October 21, 2009, 05:21	Explosion inside a cube - blockMesh	#1
shangzung Member Dennis Rown Join Date: Oct 2009 Posts: 51 Rep Power: 16	Hello! I want to model a a simple cube and simulate an explosion inside that cube. I thought of another small cube that has high pressure in it, which is ater a while released into the big cube. Since I am very new with blockMesh, for modelling that in blockMesh I have a question. How many blocks do I have to create at least? Are two blocks (big cube, small cube) enough or won't blockMesh work that way and I will have to create tons of blocks?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit help: Cube inside cube	Jack Martinez	FLUENT	13	August 11, 2010 06:29
[blockMesh] error Meshing a 3D cube geometry with blockMesh	GodOfLove	OpenFOAM Meshing & Mesh Conversion	5	July 14, 2009 15:30
A tilted 3D cube inside a wind tunnel	jam	OpenFOAM Running, Solving & CFD	5	February 29, 2008 12:21
[blockMesh] Surface mounted cube blockmesh example	braennstroem	OpenFOAM Meshing & Mesh Conversion	0	December 9, 2005 06:41
meshing F1 front wing	Steve	FLUENT	0	April 17, 2003 12:37

October 21, 2009, 07:38		#2
shangzung Member Dennis Rown Join Date: Oct 2009 Posts: 51 Rep Power: 16	I found out that I don't have to create an additional block at all for the case. Just one block is enough.

March 6, 2013, 03:59		#4
CharlieTan84 New Member Charlie Tan Join Date: Sep 2011 Posts: 23 Rep Power: 14	Hello! Which solver are you using to simulate a TNT Explosion on OpenFoam? Thank you so much!