boundary conditions for explosion in a tube

shangzung · October 28, 2009, 12:36

Hello!

I am simulating an explosion inside a tube. I can not figure out how to set the wall boundary conditions for the pressure p in the folder 0/p so that the wall pressure is calculated. Now I only can start simulation, when I set the wall boundaries for the walls to "fixedValue" and set that value to 1 bar. When I set them to "calculated", the simulation crashes in the first timestep. What am I doing wrong there?

bhh · October 29, 2009, 13:06

The boundary condition for pressure for walls should be zeroGradient.
rgds
Bjorn

October 28, 2009, 12:36	boundary conditions for explosion in a tube	#1
shangzung Member Dennis Rown Join Date: Oct 2009 Posts: 51 Rep Power: 16	Hello! I am simulating an explosion inside a tube. I can not figure out how to set the wall boundary conditions for the pressure p in the folder 0/p so that the wall pressure is calculated. Now I only can start simulation, when I set the wall boundaries for the walls to "fixedValue" and set that value to 1 bar. When I set them to "calculated", the simulation crashes in the first timestep. What am I doing wrong there?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Impinging Jet Boundary Conditions	Anindya	Main CFD Forum	25	February 27, 2016 12:58
inlet velocity boundary condition	murali	CFX	5	August 3, 2012 08:56
Boundary conditions for turbulent boundary layer	Thomas	FLUENT	1	June 17, 2008 05:14
Pressure boundary conditions	Lionel S.	Main CFD Forum	1	August 24, 2007 18:03
A problem about setting boundary conditions	lyang	Main CFD Forum	0	September 19, 1999 18:29

October 29, 2009, 13:06		#2
bhh Member Bjorn H. Hjertager Join Date: Mar 2009 Posts: 72 Rep Power: 17	The boundary condition for pressure for walls should be zeroGradient. rgds Bjorn