CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM (https://www.cfd-online.com/Forums/openfoam/)
-   -   wedge BC in OpenFOAM (https://www.cfd-online.com/Forums/openfoam/71048-wedge-bc-openfoam.html)

devesh.baghel December 14, 2009 02:55

wedge BC in OpenFOAM
 
Hi foamers

I have a doubt about the BC "wedge". I have axi-symmetric geometry (cylindrical plate) but fluid (drop of oil) is NOT at the centre (0,0,0). Can I apply wedge BC to the geometry? Like, I have meshed 60 degree secor of plate and defined 2 side faces as wedge. Will that be OK or do I need to mesh complete cylindrical plate (or half plate with symmetryPlane, running thru the center of drop, condition) for analysis to be correct?

Thanks in advance for help.

-Devesh


All times are GMT -4. The time now is 06:14.