 |
 |
 |
|
|
|
[Sponsors] | ||||
December 21, 2009, 13:11
|
Interpolation CuttingPlane to Patch
|
#1 |
|
Member
Matthias Walter
Join Date: Mar 2009
Location: Rostock, Germany
Posts: 63
Rep Power: 17  |
Hi,
I'm looking for the most efficient way to interpolate values from an internal (arbitrary) plane to a patch between different meshes (and size). My first idea was to use a cuttingPlane that intersects the source mesh at the desired position and to sample the corresponding field values along the plane. But what would be the easiest way to do the interpolation to the desired patch of the target mesh? (PatchToPachInterpolation? better alternatives?, mapFields does it only for volFields). And whats about the cell order of the sampled field values and the target patch? Best regards Matthias |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] Cyclic BC's: Possible face ordering problem? (Channel flow) | sega | OpenFOAM Meshing & Mesh Conversion | 3 | September 28, 2010 12:46 |
| [mesh manipulation] Using createPatch in place of couplePatches | sripplinger | OpenFOAM Meshing & Mesh Conversion | 8 | November 13, 2009 07:14 |
| CheckMeshbs errors | ivanyao | OpenFOAM Running, Solving & CFD | 2 | March 11, 2009 02:34 |
| [Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |
Linear Mode
