CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM (https://www.cfd-online.com/Forums/openfoam/)
-   -   my potentialFoam seems does'nt work (https://www.cfd-online.com/Forums/openfoam/71881-my-potentialfoam-seems-doesnt-work.html)

panda60 January 19, 2010 02:43
my potentialFoam seems does'nt work
 
Dear all:

my potentialFoam seems does'nt work.

Calculating potential flow
DICPCG: Solving for p, Initial residual = 0, Final residual = 0, No Iterations 0
continuity error = 0
Interpolated U error = 0
ExecutionTime = 19.07 s ClockTime = 19 s


It seems that the internalField haven't been initialised. why this happened ? If it is because my mesh was generated using Fluent ?

panda60 January 19, 2010 03:01
could anyone help me ? it seems very strange.
what I must pay attention to when using potentialFoam ?

dVoglander January 19, 2010 03:14
bc's
 
Hi,

i think you should check your boundary conditions.

panda60 January 19, 2010 08:28
Quote:
Originally Posted by dVoglander (Post 243034)
Hi,

i think you should check your boundary conditions.
Yes, dVoglander.my inflow boundary condition is not right, Thank you very much.

Iose July 20, 2021 09:07
Quote:
Originally Posted by panda60 (Post 243074)
Yes, dVoglander.my inflow boundary condition is not right, Thank you very much.
Hi panda60, what was the problem in your case?
Because I observed same strange behavior from potentionalFoam run.

Many thanks.


All times are GMT -4. The time now is 16:00.