Ft for hot combustion products
Hi,
I try to understand better the Mixture Fraction Model I should use to model a Jet in Hot Coflow by fireFoam. Should I have two different inlets (fuel inlet and oxidizer inlet) to use this Model? If it would be true, I can't use it since I won't able to set the Ft boundary condition for my third inlet (hot combustion products). Thank You very much, Cristiano |
You can just set ft equal to stoichiometric value to represent pure product in the coflow inlet.
Yi Quote:
|
Ft for hot combustion product
Hi, Combustion product composition is showed in the table below: YO2 [%] YN2 [%] YH2O [%] YCO2 [%] 3 85 6.5 5.5 Which value should I set for mixture fraction Ft boundary condition? Thank You very much, Cristiano |
All times are GMT -4. The time now is 14:14. |