fan with geometry stl

Hitomi · July 12, 2011, 16:13

Hello,

I would like to know if we can use a fan boundary condition at a geometry stl. I searched in the forum and i just find when we define the geometry of the fan in the blockMesh.

I don't speak very well english perhaps the answer is in the forum and i didn't understand.

Thank you

Sylvain · August 18, 2011, 11:27

Hi Hitomi,

I had the same problem, and I don't think it is possible to define a classical fan BC (mean pressure jump through an interface) from an STL file and using snappyHexMesh.

More since version 2.0 the way the cyclic BC are defined has changed.

For my case I meshed the whole domain with snappyHexMesh without the fan interface. then I used topoSet et createBaffle utility. you have a good example in the tutorial pimpleFoam/TjunctionFan.

There is another solution sing the fanPressure BC intruduced in 2.0.0. With this one you can define two different patches from stl files in snappyHexMesh. then you can define in your BC each one of them either as an outlet or an inlet.

Hope it is helpfull

sylvain

July 12, 2011, 16:13	fan with geometry stl	#1
Hitomi New Member Hitomi Join Date: Jul 2011 Posts: 1 Rep Power: 0	Hello, I would like to know if we can use a fan boundary condition at a geometry stl. I searched in the forum and i just find when we define the geometry of the fan in the blockMesh. I don't speak very well english perhaps the answer is in the forum and i didn't understand. Thank you

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Mesh a geometry without stl file	eysteinn	OpenFOAM Meshing & Mesh Conversion	0	May 5, 2011 10:15
Boundary conditions for a Fan geometry	saisanthoshm88	CFX	9	February 7, 2011 04:33
STL Surface Geometry Fixing	EphemeralMemory	Main CFD Forum	2	October 31, 2010 13:35
[snappyHexMesh] SnappyHexMesh meshes inside and outside of an STL geometry	villier	OpenFOAM Meshing & Mesh Conversion	17	June 15, 2010 19:51
vitual _ real	deneb	FLUENT	3	January 22, 2007 04:31

August 18, 2011, 11:27		#2
Sylvain Member Sylvain Aguinaga Join Date: Feb 2010 Posts: 41 Rep Power: 16	Hi Hitomi, I had the same problem, and I don't think it is possible to define a classical fan BC (mean pressure jump through an interface) from an STL file and using snappyHexMesh. More since version 2.0 the way the cyclic BC are defined has changed. For my case I meshed the whole domain with snappyHexMesh without the fan interface. then I used topoSet et createBaffle utility. you have a good example in the tutorial pimpleFoam/TjunctionFan. There is another solution sing the fanPressure BC intruduced in 2.0.0. With this one you can define two different patches from stl files in snappyHexMesh. then you can define in your BC each one of them either as an outlet or an inlet. Hope it is helpfull sylvain