 |
 |
 |
|
|
|
[Sponsors] | ||||
September 25, 2010, 04:14
|
VOF interface compression and mesh size
|
#1 |
|
Senior Member
Claus Meister
Join Date: Aug 2009
Location: Wiesbaden, Germany
Posts: 241
Rep Power: 17  |
Hello Foamers!
Does anybody know the relationship between interface compression and mesh size to keep the interface sharp? I.e. when I am using interface compression and a coarse mesh, do I get a sharp interface? Cheers in advance |
|
|
|
|
|
September 26, 2010, 06:36
|
|
#2 |
|
Senior Member
Sebastian Gatzka
Join Date: Mar 2009
Location: Frankfurt, Germany
Posts: 729
Rep Power: 20 |
I don't think you can improve the interface on a coarse mesh with increased interface compression.
If you need a coarse mesh and a fine interface you can try to use interDyMFoam.
__________________
Schrödingers wife: "What did you do to the cat? It's half dead!" |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| Negative Volume - TET Mesh Compression | ChesterP | FLUENT | 4 | April 11, 2010 02:49 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| increasing mesh quality is leading to poor convergence | tippo | CFX | 2 | May 5, 2009 10:55 |
| Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Linear Mode
