 |
 |
 |
|
|
|
[Sponsors] | ||||
October 4, 2010, 09:16
|
Reading chemistry from CHEMKIN inp files
|
#1 |
|
Senior Member
Adhiraj
Join Date: Sep 2010
Location: Karnataka, India
Posts: 187
Rep Power: 15  |
Hi,
I am new to OpenFOAM and want to use it to simulate laminar diffusion flames. For that I see that I need diffusion models. I am using CHEMKIN inp files for chemistry and the thermodynamic properties. I want to know where OpenFOAM reads the files, parses them and stores the information (The thermodynamic data in particular) in the files. I have not worked too much in C++ either, so I am on a rather steep learning curve here. Thanks in advance. Last edited by adhiraj; October 4, 2010 at 09:28. Reason: I need to access the thermodynamic data for my work . |
|
|
|
|
|
October 5, 2010, 08:20
|
|
#2 |
|
Senior Member
Markus Rehm
Join Date: Mar 2009
Location: Erlangen (Germany)
Posts: 184
Rep Power: 17 |
Hello,
have a look at the reactingFoam tutorial at this page http://www.tfd.chalmers.se/~hani/kurser/OS_CFD_2007/ Markus |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Problem converting fluent mesh | vinz | OpenFOAM Meshing & Mesh Conversion | 28 | October 12, 2015 06:37 |
| UDF issue | MASOUD | Fluent UDF and Scheme Programming | 14 | December 6, 2012 13:39 |
| critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
| Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |
| problem when converting mesh (made by ICEM) using fluentMeshToFoam | Forrest_Lei | OpenFOAM | 11 | October 16, 2009 06:28 |
Linear Mode
