|
[Sponsors] |
December 31, 2010, 04:51 |
Units in scalartransportfoam
|
#1 |
New Member
Join Date: Oct 2010
Posts: 3
Rep Power: 15 |
Hello,
I'm wondering about the dimensions of DT in scalartransportfoam. The wiki says the diffusion coefficient is divided by the fluid density, but in constant/transportProperties the dimensions are set to be Code:
DT [0 2 -1 0 0 0 0] Am I overlooking something? Thank you in advance Frithjof Last edited by Frithjof; December 31, 2010 at 06:41. |
|
January 5, 2011, 10:41 |
|
#2 |
New Member
Alton Luder III
Join Date: Oct 2009
Location: Michigan
Posts: 22
Rep Power: 16 |
Its the same as nu, ie mu/rho.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDS source term units | Ale | FLUENT | 3 | March 29, 2017 07:08 |
units of geometrical parameters lost | SoobY | ANSYS Meshing & Geometry | 2 | January 10, 2011 03:58 |
Mass transfer units in fluent | nite_surfer | FLUENT | 0 | July 12, 2007 12:51 |
Units for Contaminant Concentration | Rob | Phoenics | 1 | March 30, 2005 10:06 |
To dimensionalize or not to dimensionalize !! | tolani owosina | Main CFD Forum | 8 | November 13, 1999 13:45 |