|
[Sponsors] |
February 2, 2011, 00:59 |
variable boundary height.
|
#1 |
Senior Member
Join Date: Mar 2009
Posts: 225
Rep Power: 18 |
I am trying to set up variable height boundary condition. What I would like to define is boundary inflow boundary condition which increases higher and higher as time of the simulation passes.
Ideally, what would be the perfect solution is something as the ramp inlet velocity similar as described in Transient boundary condition. However, instead of velocity I would like to use variable height. Any tips? Many very thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Variable names for mass flux for a recirculating-outlet boundary condition | BRNN | Fluent UDF and Scheme Programming | 7 | September 4, 2018 13:49 |
How can I impose variable boundary conditions? | behrang2009 | FLUENT | 2 | December 20, 2009 20:26 |
Additional variable - wall boundary condition | flga | CFX | 2 | May 30, 2007 03:14 |
Height of boundary layer | DAK565656 | CFX | 2 | April 19, 2007 11:30 |
Env variable not set | gruber2 | OpenFOAM Installation | 5 | December 30, 2005 04:27 |