 |
 |
 |
|
|
|
[Sponsors] | ||||
After topological changes correct boundaries ? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 24, 2011, 02:47
|
After topological changes correct boundaries ?
|
#1 |
|
Senior Member
Join Date: Oct 2009
Posts: 140
Rep Power: 16  |
Hi Foamers
I am doing mesh motion with topological changes (attachdetach boundarys and layering) The mesh moves without problems but when I introduce a flow solver I ve encountered some difficulties. The solver runs without problems but when I introduce the attachdetach faces it fails before entering into the flow solver. I ve read that I need to update my boundaries after introducing attachdetach faces or in general after a topological change. Bur how? Perhaps the correctPhi.H should be called,? I appreciate any help. Peter |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| Setting Flow/Pressure Boundaries in Floworks | Eran | FloEFD, FloWorks & FloTHERM | 3 | August 11, 2009 04:23 |
| Correct location for inflow and outflow boundaries | Varun | CFX | 1 | May 23, 2008 03:43 |
| problems replacing old boundaries | Jared | Siemens | 4 | August 5, 2005 19:36 |
| mass flux correction at outflow boundaries | Subhra Datta | Main CFD Forum | 2 | November 24, 2003 13:11 |
Linear Mode
