|
[Sponsors] |
April 14, 2011, 11:52 |
Issue in checkMesh (?)
|
#1 |
Member
José
Join Date: Jan 2011
Posts: 73
Rep Power: 15 |
Dear all,
I am doing a study in stopped 2D airfoils with a blunt trailing edge using O-meshes and it has happened to me that when I generate a mesh using fluent3DMeshToFoam and I do a "checkMesh" I obtain a warning for high aspect ratio cells (max AR about 5000). Then I run it and once the computation has started and some time directories have been created I do the checkMesh again and this warning does not appear any more (it says max AR of about 250). Does any body have any explanation for that? Thank you for your attention. Best Regards, José |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] How to delete cells in OF based on CheckMesh? | AndTen | OpenFOAM Meshing & Mesh Conversion | 15 | July 27, 2018 07:13 |
[CGNS] checkMesh Error - Number of regions: 5 | lentschi | OpenFOAM Meshing & Mesh Conversion | 1 | March 11, 2011 05:35 |
OpenFOAM-1.5-extend checkMesh problem | josp | OpenFOAM Bugs | 2 | June 24, 2009 12:41 |
[Other] CheckMesh for mesh quality | gdbaldw | OpenFOAM Meshing & Mesh Conversion | 2 | October 18, 2007 01:11 |
Issue 4 of adapco-online | Sreenadh Jonnavithula | Siemens | 0 | December 21, 2000 14:41 |