[NewKid]

Hi, everyone, I run into a problem of making blockMeshDict file of such a mesh in attachement:

In fact, the edge between point 17 and 8 should be a arc, but hard to draw it, I draw a line indeed.

PS: I split the whole block into 3 sub-blocks along Z-axis, and those red dash lines show the edge of each sub-blocks.
How to make the correct blockMeshDict file of this mesh or any better way to split the whole block?
Thanks!

[andrea.pasquali]

Maybe you can follow the blockMeshDict.m4 inside the MRFSimpleFoam tutorial.
You have to write a .m4 file and run it to obtain the blockMeshDict.

regards

Andrea

[NewKid]

.m4 file?
I'll check it ASAP.

Thanks!