Motorbike Tutorial

ChrisPro · June 7, 2011, 09:45

Hello!

I've searched the internet for hours but couldn't find the motorbike tutorial!
So could someone please send me the link to it?

regards
Chris

bastil · June 7, 2011, 11:38

Hi,

this tutorial is part of each OpenFOAM distribution. Look under tutorials/incompressible/simpleFoam. The director structure may be little different depending from the version of OpenFOAM.

Regards Bastian

ChrisPro · June 7, 2011, 11:47

hey basti!

yes, I found this data, but I thought there would be some instructions like for those easy tutorials on openfoam.com, like the cavity example...

is there something like that?

vatavuk · June 8, 2011, 08:37

Hi Chris,
The sequence of commands to run a tutorial is the same as that given in the allrun script file, that appears in the same directory. To run snappyHexMesh you may find additional information in the user guide.
Paulo

ChrisPro · June 8, 2011, 09:29

Ok, Thanks!

I did it!

June 7, 2011, 09:45	Motorbike Tutorial	#1
ChrisPro Member Join Date: Jun 2011 Posts: 38 Rep Power: 14	Hello! I've searched the internet for hours but couldn't find the motorbike tutorial! So could someone please send me the link to it? regards Chris

June 8, 2011, 08:37		#4
vatavuk Senior Member Paulo Vatavuk Join Date: Mar 2009 Location: Campinas, Brasil Posts: 196 Rep Power: 17	Hi Chris, The sequence of commands to run a tutorial is the same as that given in the allrun script file, that appears in the same directory. To run snappyHexMesh you may find additional information in the user guide. Paulo Last edited by vatavuk; June 9, 2011 at 07:54. Reason: correct small errors

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Trying to understand the motorBike tutorial	Andyjoe	OpenFOAM Meshing & Mesh Conversion	10	August 10, 2014 16:57
motorBike tutorial and Scaling - New geometry used, scaled and now large velocity!!!	scott	OpenFOAM	1	July 29, 2010 04:09
motorBike tutorial doesn't work out-of-the-box	Wolle	OpenFOAM	23	April 21, 2010 08:19
InletOutlet boundary condition in motorBike tutorial	madad2005	OpenFOAM	2	November 27, 2009 08:15
FoamToEnsight/EnsightParts/VTK not working with motorbike tutorial	madad2005	OpenFOAM Bugs	5	October 18, 2009 04:48

June 7, 2011, 11:38		#2
bastil Senior Member BastiL Join Date: Mar 2009 Posts: 530 Rep Power: 20	Hi, this tutorial is part of each OpenFOAM distribution. Look under tutorials/incompressible/simpleFoam. The director structure may be little different depending from the version of OpenFOAM. Regards Bastian

June 7, 2011, 11:47		#3
ChrisPro Member Join Date: Jun 2011 Posts: 38 Rep Power: 14	hey basti! yes, I found this data, but I thought there would be some instructions like for those easy tutorials on openfoam.com, like the cavity example... is there something like that?

June 8, 2011, 09:29		#5
ChrisPro Member Join Date: Jun 2011 Posts: 38 Rep Power: 14	Ok, Thanks! I did it!