|
[Sponsors] |
June 28, 2011, 22:30 |
Pressure Boundary Condition
|
#1 | ||
New Member
Miguel Suarez
Join Date: Aug 2010
Location: El Paso Texas
Posts: 28
Rep Power: 15 |
I am using Openfoam 1.7 chtMultiRegionSimpleFoam solver and I'm trying to get the same results as in Fluent. However, I'm getting different results (Pressure and Velocity).
My case is as follows: Straight duct with a constant temperature bottom wall. the area of the inlet is 4x10-6 m^2. Reynolds no of 2000 (laminar flow). length of pipe is .25 m The following are my boundary conditions Quote:
Quote:
fixedValue zeroGradient inletOutlet etc I have not tried freeStreamPressure because i Dont know if it applies in this case Any help is greatly appreciated!!!! PLEASE HELP!!!!!!!! The problem with my results is that my velocity decreases at the outlet. the initial velocity at the inlet is approx 10.4 m/s, at the outlet i'm getting velocities less than 3 m/s... which does not make sense Miguel Last edited by masuarez; June 28, 2011 at 22:37. Reason: missing information |
|||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Pressure boundary condition | C-H Kuo | Main CFD Forum | 18 | September 16, 2016 03:19 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
how can i give a boundary condition with pressure and velocity together | akhenathon | FLUENT | 6 | April 24, 2012 18:32 |
Pressure Boundary condition | abishek | FLUENT | 1 | July 28, 2008 08:14 |