any access to update mass injected in InjecteModel?

alundilong · July 3, 2011, 01:45

Hi FOAMers,
Is there an available access in InjectionModel to update injected mass instead of setting the mass total value in dictionary?

I'm trying to build an solver similar to coalChemicalFoam, but the injected mass is related to the temperature field in the gas domain. I looked hard, but failed to see any access to update the injected mass.

Any suggestion will be appreciated!

Here is the available options for injectionModels,
Manualnjection
PatchInjection
ConeInjection
ConeInjectionMP
FieldActivatedInjection
BTW, I'm using openfoam 1.7.x

alundilong · July 3, 2011, 16:47

could anyone give me a hint, thanks

should I have to develop a new injectionmodel?

July 3, 2011, 01:45	any access to update mass injected in InjecteModel?	#1
alundilong Member yijin Mao Join Date: May 2010 Location: Columbia, MO Posts: 62 Rep Power: 15	Hi FOAMers, Is there an available access in InjectionModel to update injected mass instead of setting the mass total value in dictionary? I'm trying to build an solver similar to coalChemicalFoam, but the injected mass is related to the temperature field in the gas domain. I looked hard, but failed to see any access to update the injected mass. Any suggestion will be appreciated! Here is the available options for injectionModels, Manualnjection PatchInjection ConeInjection ConeInjectionMP FieldActivatedInjection BTW, I'm using openfoam 1.7.x

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Running dieselFoam error	adorean	OpenFOAM Running, Solving & CFD	119	February 1, 2016 14:41
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
Problem setting with chtmultiregionFoam	Antonin	OpenFOAM	10	April 24, 2012 09:50
Slightly increasing value of injected mass even after end of injection	Rickard.Solsjo	OpenFOAM	0	January 20, 2011 03:53

July 3, 2011, 16:47		#2
alundilong Member yijin Mao Join Date: May 2010 Location: Columbia, MO Posts: 62 Rep Power: 15	could anyone give me a hint, thanks should I have to develop a new injectionmodel?