|
[Sponsors] |
any access to update mass injected in InjecteModel? |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
yijin Mao
Join Date: May 2010
Location: Columbia, MO
Posts: 64
Rep Power: 16 ![]() |
Hi FOAMers,
Is there an available access in InjectionModel to update injected mass instead of setting the mass total value in dictionary? ![]() I'm trying to build an solver similar to coalChemicalFoam, but the injected mass is related to the temperature field in the gas domain. I looked hard, but failed to see any access to update the injected mass. Any suggestion will be appreciated! Here is the available options for injectionModels, Manualnjection PatchInjection ConeInjection ConeInjectionMP FieldActivatedInjection BTW, I'm using openfoam 1.7.x |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Member
yijin Mao
Join Date: May 2010
Location: Columbia, MO
Posts: 64
Rep Power: 16 ![]() |
could anyone give me a hint, thanks
![]() should I have to develop a new injectionmodel? |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
Running dieselFoam error | adorean | OpenFOAM Running, Solving & CFD | 119 | February 1, 2016 15:41 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
Problem setting with chtmultiregionFoam | Antonin | OpenFOAM | 10 | April 24, 2012 10:50 |
Slightly increasing value of injected mass even after end of injection | Rickard.Solsjo | OpenFOAM | 0 | January 20, 2011 04:53 |