 |
 |
 |
|
|
|
[Sponsors] | ||||
July 4, 2011, 10:53
|
Mesh tetrahedral with firefoam 1.7
|
#1 |
|
New Member
Nguyen
Join Date: May 2011
Location: Poitiers, France
Posts: 4
Rep Power: 16  |
Hello all,
I am trying to do the simulation of combustion of mixing CH4 + air in the cone calorimeter with Firefoam. I have done the mesh 3D tetrahedral in Gambit and I used the command Fluent3DmeshToFoam for use it with Firefoam. But when I run it with Firefoam, the calcul stoped at t = 0.00517007 with message Temperature is out of range. I think the problem is the mesh tetrahedral. Someone can tell me what do I do to solve my problem. Thank you very much NTD |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
| setFields doesn't function for a tetrahedral mesh - interFoam | tommie | OpenFOAM Pre-Processing | 5 | April 15, 2010 04:32 |
| incorrect results with a tetrahedral mesh | jcmasters | OpenFOAM | 5 | May 20, 2009 17:44 |
| basic of mesh refinement | arya | CFX | 4 | June 19, 2007 13:21 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |
Linear Mode
