|July 7, 2011, 04:18||
shallowWaterFOAM input files
Join Date: Jun 2011
Posts: 1Rep Power: 0
My question concerns the input-files needed for shwalloWaterFOAM-solver. Does anyone konw in detail the difference between files (h, h0, hTotal) . I found a presentation within the files are described as follow
h = mean surface height
h0 = deviation from the mean surface height
hTotal = free-surface
My lack of understanding: where one could define the surface (terrain). Is it possible at all? Because if I start the solver both files (h and h0) changing thier values. But the terrain surface should be time constant.
Currently I am using OpenFOAM 2.0.
|October 30, 2011, 14:48||
Join Date: Aug 2009
Location: Stuttgart / Germany
Posts: 31Rep Power: 9
I'm facing the same problem. I build up a test case and h values are changing. Did you found a solution so far? I also want introduce bathymetry data or terrain data, respectively .
I would be happy, if you could share your solution!
|August 31, 2016, 01:18||
Join Date: Aug 2016
Posts: 4Rep Power: 2
I want to use shallowwaterFOAM case for tidal water simulation. In Telemac 2d, bottom surface is given as a input. In this bottom surface file is prepared by interpolating given bathymetry points at mesh nodes.
In shallowwaterFOAM I have not found any option to generate such bottom surface file and to use such bottom surface. In this case bottom surface is taken as a plane surface.
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF issue||MASOUD||Fluent UDF and Scheme Programming||14||December 6, 2012 14:39|
|critical error during installation of openfoam||Fabio88||OpenFOAM Installation||21||June 2, 2010 03:01|
|OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found||piprus||OpenFOAM Installation||22||February 25, 2010 14:43|
|Problems in compiling paraview in Suse 10.3 platform||chiven||OpenFOAM Installation||3||December 1, 2009 08:21|
|OpenFOAM15 paraFoam bug||koen||OpenFOAM Bugs||19||June 30, 2009 10:46|