|
[Sponsors] |
August 4, 2011, 02:08 |
OpenFoam to Fluent data conversion Problem
|
#1 |
New Member
KKV
Join Date: May 2009
Posts: 18
Rep Power: 17 |
Hello,
I am working with simple pipe flow with porous domain and the wall of the porous zone is considered as slip wall. After solving i saw there are differences when viewing the results in Paraview and data converting to Fluent and viewing the results in Fluent. 1. At the inlet i saw there are differences in velocity magnitude and pattern of contours. 2. At the midplane which cuts the slip wall, paraview showing the velocity magnitude without zero velocities at wall ( outer boundary). But Fluent after transferring the data shows zero velocity at the wall for mid plane. Please help me where i made a mistake in transfering the data. I am using following file for converting the openfoam data to Fluent /*--------------------------------*- C++ -*----------------------------------*\ | ========= | | | \\ / F ield | OpenFOAM: The Open Source CFD Toolbox | | \\ / O peration | Version: 2.0.0 | | \\ / A nd | Web: www.OpenFOAM.com | | \\/ M anipulation | | \*---------------------------------------------------------------------------*/ FoamFile { version 2.0; format ascii; class dictionary; location "system"; object foamDataToFluentDict; } // * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * // p 1; U 2; T 3; h 4; k 5; epsilon 6; gamma 150; // ************************************************** *********************** // |
|
August 8, 2011, 03:30 |
Problem with Fluent data conversion
|
#2 |
New Member
KKV
Join Date: May 2009
Posts: 18
Rep Power: 17 |
Hello Users,
Please help me where i wet wrong in converting the OpenFoam data file to Fluent format. Regards Krishna |
|
Tags |
fluent data conversion |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reading Additional Data Quantities from Fluent into Tecplot | fremder | Tecplot | 9 | December 16, 2016 16:35 |
Fluent case to OpenFOAM conversion | umichsct | OpenFOAM | 4 | April 23, 2011 15:59 |
Convertation axisymmetric cases from Fluent to OpenFOAM | Svensson | OpenFOAM | 0 | April 19, 2011 07:08 |
Tecplot360 problem for reading OpenFOAM data | maysmech | OpenFOAM Post-Processing | 5 | April 13, 2011 16:37 |
OpenFOAM Install problem | masb | OpenFOAM | 3 | May 25, 2009 12:32 |