 |
 |
 |
|
|
|
[Sponsors] | ||||
[mesh manipulation] visualize the bad elements |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 19, 2011, 04:11
|
visualize the bad elements
|
#1 |
|
Member
ynos
Join Date: Jan 2011
Posts: 39
Rep Power: 15  |
Hi there
How is possible visualize the bad cells with paraview??? Thanks |
|
|
|
|
|
August 19, 2011, 04:12
|
visualize the bad elements
|
#2 |
|
Member
ynos
Join Date: Jan 2011
Posts: 39
Rep Power: 15 |
Sorry
I work the mesh with openfoam Thanks in advance |
|
|
|
|
|
|
September 9, 2011, 14:35
|
|
#3 |
|
Senior Member
Daniel P. Combest
Join Date: Mar 2009
Location: St. Louis, USA
Posts: 621
Rep Power: 0 |
If you have a set that contains a list of the bad cells, then you can select "include sets" from the object inspector when you first start parafoam. These sets of bad cells can be generated by you, using cellSet, or they can be those produced by checkMesh utility. Hope that helps.
Dan |
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3D Windturbine simulation in SU2 | k.vimalakanthan | SU2 | 15 | October 12, 2023 05:53 |
| [ICEM] Bad elements along a curved vanes | Julian121 | ANSYS Meshing & Geometry | 2 | October 21, 2018 07:15 |
| Ansys SIG$ILL error | loth | ANSYS | 3 | December 24, 2015 05:31 |
| [ICEM] How to improve bad quality elements that are obtained after creating prism layers? | Rohith Giridhar | ANSYS Meshing & Geometry | 2 | July 11, 2015 18:04 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
