CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM (
-   -   ignition, parallel runs - janaf error (

newOFuser September 11, 2011 17:14

ignition, parallel runs - janaf error
Hi all,

I am trying to run a simple simulation of combustion in a backward facing step. The code involves ignition after a few time steps, which works okay on a single processor. When I run the code is parallel, however, the temperature keeps increasing till it crosses 5000K and shows up as a janaf error.

Any idea why this may be happening or how to get rid of this?

Many thanks

All times are GMT -4. The time now is 20:55.