 |
 |
 |
|
|
|
[Sponsors] | ||||
September 11, 2011, 17:14
|
ignition, parallel runs - janaf error
|
#1 |
|
Member
ak
Join Date: May 2011
Posts: 64
Rep Power: 14  |
Hi all,
I am trying to run a simple simulation of combustion in a backward facing step. The code involves ignition after a few time steps, which works okay on a single processor. When I run the code is parallel, however, the temperature keeps increasing till it crosses 5000K and shows up as a janaf error. Any idea why this may be happening or how to get rid of this? Many thanks amit |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
| c++ libraries and solver compiling | vaina74 | OpenFOAM Installation | 13 | February 3, 2012 17:43 |
| OpenFOAM install on Ubuntu Natty 11.04 | bkubicek | OpenFOAM | 13 | May 26, 2011 05:48 |
| Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |
| Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |
Linear Mode
