 |
 |
 |
|
|
|
[Sponsors] | ||||
September 12, 2011, 11:18
|
Forces in solidDisplacementFoam
|
#1 |
|
New Member
Florian
Join Date: Jan 2011
Location: Mannheim, Germany
Posts: 24
Rep Power: 16  |
Hi,
I'm using solidDisplacementFoam to simulate steady-state stress analysis on a gear. For this I would like to set a force along a line as boundary condition. Is there any possibility to do this in solidDisplacementFoam?? Thanks for you help Riesotto |
|
|
|
|
|
September 12, 2011, 17:19
|
|
#2 | |
|
Super Moderator
Philip Cardiff
Join Date: Mar 2009
Location: Dublin, Ireland
Posts: 1,104
Rep Power: 35 |
Quote:
SolidDisplacementFoam is based on finite volume stress analysis and as such it is only possible to apply boundary conditions to faces (not points or lines as in finite elements). So it would be possible along a line of faces if that would do. Philip |
||
|
|
|
||
|
September 13, 2011, 02:50
|
|
#3 |
|
New Member
Florian
Join Date: Jan 2011
Location: Mannheim, Germany
Posts: 24
Rep Power: 16 |
Hi Philip,
thank you for your reply. I will think about it and simulate the force along a line of faces. riesotto |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reading forces from previous time step within solver | SD@TUB | OpenFOAM Programming & Development | 5 | April 24, 2023 11:51 |
| how to get forces on Iso-Clip Surfaces and How to get forces in cylindrical coordinat | CFD XUE | FLUENT | 3 | March 18, 2015 03:28 |
| FORCES don't run! | C12Carbon | OpenFOAM | 0 | September 10, 2011 07:34 |
| Calculate forces without hydrostatic pressure | geir_oye | FLUENT | 4 | November 12, 2009 09:12 |
| Valve Forces in CFdesign | Mike Clapp | Main CFD Forum | 3 | March 8, 2001 14:09 |
Linear Mode
